SE95D,112【PDF 12/27 页】IC SENSOR TEMP 2.8-5.5V SOT96-1

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录46

8页 9页 10页 11页 [12页]13页 14页 15页 16页

SE95_7

Product data sheet

Rev. 07 2 September 2009

12 of 27

NXP Semiconductors

SE95

Ultra high accuracy digital temperature sensor and thermal watchdog

8.7 Protocols for writing and reading the registers

The communication between the host and the SE95 must follow the rules strictly as

dened by the I

C-bus management. The protocols for SE95 register read/write

operations are illustrated in

Figure

5 to

Figure

10 together with the following denitions:

1. Before a communication, the I

C-bus must be free or not busy. It means that the SCL

and SDA lines must both be released by all devices on the bus, and they become

HIGH by the bus pull-up resistors.

2. The host must provide SCL clock pulses necessary for the communication. Data is

transferred in a sequence of 9 SCL clock pulses for every 8-bit data byte followed by

1-bit status of the acknowledgement.

3. During data transfer, except the START and STOP signals, the SDA signal must be

stable while the SCL signal is HIGH. It means that the SDA signal can be changed

only during the LOW duration of the SCL line.

4. S: START signal, initiated by the host to start a communication, the SDA goes from

HIGH-to-LOW while the SCL is HIGH.

5. RS: RE-START signal, same as the START signal, to start a read command that

follows a write command.

6. P: STOP signal, generated by the host to stop a communication, the SDA goes from

LOW-to-HIGH while the SCL is HIGH. The bus becomes free thereafter.

7. W: write bit, when the write/read bit is in a write command.

8. R: read bit, when the write/read bit is logic 1 in a read command.

9. A: device acknowledge bit, returned by the SE95. It is logic 0 if the device works

properly and logic 1 if not. The host must release the SDA line during this period in

order to give the device the control on the SDA line.

10. A: master acknowledge bit, not returned by the device, but set by the master or host

in reading 2-byte data. During this clock period, the host must set the SDA line to

LOW in order to notify the device that the rst byte has been read for the device to

provide the second byte onto the bus.

11. NA: not-acknowledge bit. During this clock period, both the device and host release

the SDA line at the end of a data transfer, the host is then enabled to generate the

stop signal.

12. In a write protocol, data is sent from the host to the device and the host controls the

SDA line, except during the clock period when the device sends the device

acknowledgement signal to the bus.

13. In a read protocol, data is sent to the bus by the device and the host must release the

SDA line during the time that the device is providing data onto the bus and controlling

the SDA line, except during the clock period when the master sends the master

acknowledgement signal to the bus.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式